Standard installation on Samsung TEP
Basic installation steps
Before installing the application, it is advised to do the following steps
- Press MENU on your remote
- Reset System Settings via
System
>Reset System
- Empty Storage via
General
>Empty Storage
- Set the time via
System
>Time
>Clock Set
- If you want to change the device's time zone through our application later, you need to set the NTP server in
System
>Time
>NTP Settings
- Go to Power Control options via
System
>Power Control
Auto Power On
causes the device to switch on automatically when it is connected to the power source. It is useful against power shortages. Switch this on.Max Power Saving
turns the monitor off occasionally so we advise you to switch this off.
- Go to
Eco Solution
viaSystem
>Eco Solution
- Disable
Energy Saving Mode
,No Signal Power off
, andAuto Power off
options.
- Disable
The following steps are required to be able to install the application
- Set the player type to URL Launcher via
System
>Play via
- Go to
System
>Auto Source Switching
- Disable Auto Source Switching
- Press the HOME button on the remote
- Select URL Launcher Settings option
Installing through URL Launcher
- Type the URL to the Install Web App section then select OK:
Here is an example URL
https://example.domain.com/api/storage/update/jscore/samsung-tizen/
- The application installs and once the installation is complete the application will run automatically.
Please note
If you receive any of the following messages
Unable to connect to server. Please try again later.
The server URL is invalid. Enter the correct URL.
Please check if the correct URL is set.
Please also check the device’s time settings. The device requires the correct time to send out requests successfully!
- Press the Source button on the remote and select the source URL Launcher
- Once the application is running, you need to type the server's URL. The arrow buttons on the remote open the virtual keyboard to let you type with the remote or with an external keyboard. When you finish typing, you can set the server by pressing the Done button on the virtual keyboard. If you exit input mode, you can reenter it by pressing the Enter button on the remote.
After the installation is complete you can register your screen in the editor interface with the four-digit code displayed in the bottom-left corner of the screen.